Hycnc NEMA23 2nm Close Loop Stepper Motor Kit 57 Motor Shaft 6.35mm 8mm AMP Dm542-05 Driver Leadshine Original 20-50VAC 1A to 4A

Descrizione

HYCNC Nema23 2nm close loop stepper motor kit 57 motor shaft 6.35mm 8mm & dm542-05 driver Leadshine original 20-50VAC 1A to 4A

1.Nema23 stepper motor 2NM

2.Leadshine dma542-05 driver

The stepper motor is an open-loop controller that converts electric pulse signals into angular or linear displacement. When not overloaded, the speed and stop position of the motor only depend on the frequency and number of pulse signals. When the driver receives a pulse signal, it drives the stepper motor to rotate a fixed angle data in the set direction, called “Step angle”, its rotation runs step by step at a fixed angle. You can control the angular displacement by controlling the pulse numbers to achieve accurate positioning; at the same time, you can control the speed and acceleration of the motor rotation by controlling the pulse frequency, so to achieve the purpose of speed regulation.

Descrizione	DM542
Descrizione	Minimum	Typical value	Massimo	unit
Output current	1.0	–	4.2	UN
Input power supply voltage	18	36	48	VCC
Control signal input current	7	10	16	mA
Step pulse frequency	0	–	200	kHz
Resistenza di isolamento	500			MΩ

1.The wiring of the motor is subject to the description of the motor data

2.DM542 driver can only drive two-phase hybrid stepper motors, but cannot drive three-phase and five-phase stepper motors

3.How to judge whether the stepping motor is connected in series or in parallel is correct: directly rotate the shaft of the motor by hand without connecting to the drive. If it can rotate easily and evenly, it means the wiring is correct. If the resistance is large and uneven Accompanied by a certain sound, it indicates that the wiring is wrong.

Confezione & Spedizione

Informazioni aziendali