Descrizione
C2 series dismountable hall effect current sensor is an open loop device based on the measuring principle of the hall effect, with a galvanic isolation between primary and secondary circuit. It provides accurate electronic measurement of DC, AC or pulsed currents.
| Electrical data (Ta=25ºC±5ºC,RL=2KΩ,CL=10000PF) |
| Tipo | C2-100A | C2-200A | C2-300A | C2-400A | C2-500A | Unit |
| Corrente nominale(Ipn) | ±100 | ±200 | ±300 | ±400 | ±500 | UN |
| Measure range(Ip) | 0-±200 | 0-±400 | 0-±600 | 0-±800 | 0-±1000 | UN |
| Rated output | @Ip=±Ipn ±4±1% | V | ||||
| Tensione di alimentazione | ±12,±15 | V | ||||
| Power Consumption | <25 | mA | ||||
| Offset voltage | @Ip=0 ±20 | mV | ||||
| Magnetic offset | @Ip=±Ipn-0 ±20 | mV | ||||
| Offset drift | @ -40~+85ºC ≤±1 | mV/ºC | ||||
| Output drift | @ -40~+85ºC ≤±1 | mV/ºC | ||||
| Linearity | @Ip=0-±Ipn ≤1 | %FS | ||||
| Tempo di risposta | @50A/μS, 10%-90% ≤5 | μs | ||||
| Galvanic isolation | @ 50HZ,AC,1min 2.5 | Kv | ||||
| Isolation resistance | @ DC 500V 1000 | MΩ | ||||
| Applicazioni |
·Variable speed drives
·Welding machine
·Battery supplied applications
·Uninterruptible Power Supplies (UPS)
·Electrochemical
| Mechanical dimension(for reference only) |
Osservazioni:
1. All dimensions are in mm.
2. General tolerance ±1mm.
3. Elucidation: 1:+15V 2:-15V 3:V0UT 4:0V
| Directions for use |
1. When the current will be measured goes through a sensor, the voltage will be measured at the output end.(Note: The false wiring may result in the damage of the sensor)
2. Custom design in the different rated input current and the output voltage are available.
| Standards |
·UL94-V0.
·EN60947-1:2004
·IEC60950-1:2001
·EN50178:1998
·SJ 20790-2000
| General date |
| Valore | Unit | |
| Temperatura operativa(TA) | -40 A +85 | ºC |
| Temperatura di conservazione(TS) | -40 A +125 | ºC |
| Mass(ca) (M) | 70 | G |
| Characteristics chart |
Pulse current signal response characteristic:
Effects of impulse noise:
