La description
P50 Current Transformer with Clamp-on 1000A/1A
The model P50 current transformer clamp is designed for fast and easy measure the current in industrial and power environment, it has wide range of current measurement.current clamp p50 price is cheaper than CA current clamp, low phase shift, high precision 0.1% and good quality!
S type and P type, Q type AC Current Clamp are designed to extend the current measuring capabilities of DMMs or BNC, power instruments, oscilloscopes, hand-held scopes, recorders or loggers, clamp type grounding resistance tester, double clamp phase angle meter, energy meter calibrator and other diverse instruments.
The current clamp is placed around the current-carrying conductor to perform non-contact current measurements without interrupting the circuit under test. The clamp outputs current or voltage signals directly proportional to the measured current, thereby providing current measuring and displaying capabilities to instruments with low current or voltage inputs.
The model P50 current transformer clamp is designed for fast and easy measure the current in industrial and power environment, it has wide range of current measurement.current clamp p50 price is cheaper than CA current clamp, low phase shift, high precision 0.1% and good quality!
S type and P type, Q type AC Current Clamp are designed to extend the current measuring capabilities of DMMs or BNC, power instruments, oscilloscopes, hand-held scopes, recorders or loggers, clamp type grounding resistance tester, double clamp phase angle meter, energy meter calibrator and other diverse instruments.
The current clamp is placed around the current-carrying conductor to perform non-contact current measurements without interrupting the circuit under test. The clamp outputs current or voltage signals directly proportional to the measured current, thereby providing current measuring and displaying capabilities to instruments with low current or voltage inputs.
FEATURES
Suitable for 1000A cable online measurement
Holding wire diameter: φ50mm
Dimension: 101mm×219mm×26mm
Load capacity: mA output≤4Ω, 1A output 0.1Ω, 5A output 2.5VA
Installation: clamp type
Output mode: lead output
PARAMETERS
Electrical parametersMechanical parameters
| Ratio | 1000: 1 ou 2000:1 (customized) |
| Accuracy class | 0.1%, 0.2%, 0.5% |
| Primary current | 0 – 1000A AC |
| Secondary current | 0 – 5A AC (customized) |
| Max. Cont. Input current | 1200UN |
| Over voltage category | CAT III 600V |
| Output signal | 500mame,1UN,5A AC at nominal input current |
| Frequency range | 40Hz-2000Hz |
| Dielectric strength | 3KV 50Hz/60Hz at 1 minute |
| Temperature range | -20°C to +55°C |
| Sortir | 2.5 meter cable with D01 connector |
| Max. voltage not insulated conductors | 600 V |
| Standard | EN 61010-1, EN 61010-2-032, IEC60044-1 |
| Installation | Clamp type |
| Output mode | Lead output(2.5m) |
| Dimensions (L x W x H) (millimètre) | 102.9 x 219.6 x 28 |
| Masse (g) | 550 |
| Holding wire diameter (millimètre) | φ50 |
| Max. jaw opening (millimètre) | 50 |
| Jaw Color | Blue |
| Matériel | PC+ABS+Polycarbonate, UL94 V0 |
PHOTO
