Beskrivelse
The Delin Comm DM1513-G is a complete GPS&GLONASS engine module that features super
sensitivity , ultra low power and small form factor. The GPS&GLONASS signal is applied to the antenna input
of module , and a complete serial data message with position, velocity and time information is presented at the
serial interface with NMEA protocol or custom protocol .
Its -165dBm tracking sensitivity extends positioning coverage into place like urban canyons og dense
foliage miljø where the GPS&GLONASS was not possible before. The small form factor and low power consumption make the module easy to integrate into portable device like PNDs, mobile phones, cameras and vehicle navigation systems.
Ansøgninger
- LBS (Location Based Service)
- PND (Portable Navigation Device)
- Vehicle navigation system
- Mobile phone
Funktioner
- Build on high performance, low-power MediaTek MT3333 chip set
- Ultra high Track sensitivity: -165dBm
- Extremely fast TTFF at low signal level
- Built in high gain LNA
- Low power consumption: Maks [email protected]
- NMEA-0183 compliant protocol or custom protocol
- Driftsspænding: 2.8V to 4.3V
- Operating temperature range:-40to85ºC
- Patch Antenna Størrelse: 12x12x4mm
- Module Size: 15.2×13.0x6.4m
- Communication type: UART/TTL
- RoHS compliant (Lead-free)
Key Feature
| Parameter | Specifikation |
| Strømforsyning |
|
| Power Consumption |
|
| Receiver Type |
|
| Sensitivity |
|
| TTFF (EASY enabled) |
|
| TTFF (EASY disabled) |
|
| Horizontal Position Accuracy (Autonomous) |
|
| Max Update Rate |
|
| Accuracy of 1PPS Signal |
|
| Acceleration Accuracy |
|
| Dynamic Performance |
|
|
UART Port |
|
| Temperature Range |
|
| Physical Characteristics |
|
UART Ports
The module supports two full duplex serial channels UART. All serial connections are at 3V CMOS logic levels, if need different voltage levels, use appropriate level shifters. The baud rate of both serial ports are fully programmable, the data format is however fixed: x, N, 8, 1, i.e. X baud rate, no parity, eight data bits and one stop bit, no other data formats are supported, LSB is sent first. The modules default baud rate is set up 9600bps, however, the user can change the default baud rate to any value from 4800 bps to 115kbps. UART port can be used for firmware upgrade, NMEA output and PMTK proprietary commands input.
Product Picture

